Clean All Company's 

WASTEWATER EVAPORATION SYSTEMS

Hammond Lead Products (a zero discharge facility) reports 9000 gallons of lead contaminated waste-water reduced to a single 55 gallon drum! Saving thousands of dollars in disposal costs! 

Maintenance supervisor Bill Conover states:

 "It only costs us 5 cents per gallon to evaporate our waste-water!"

"We tested other evaporators and Clean All Company provided the best choice!"


Models 1000,1500, 2500 and 5500: Wastewater evaporators are constructed
of stainless or powder coated steel for durability. Wastewater is pumped, batch fed or
poured into the evaporator. Non-emulsified oils are skimmed and channeled to
an external receptacle. 

This system has underfloor heating to handle high suspended solids. The solids concentrate
and remain in the evaporator. 

It is easy to use and the flat floor simplifies cleaning. There is a three inch drain port on each
system for convenient cleaning. 

Evaporation is economic and reduces wastewater disposal costs. Substantial cost savings can be generated from reduced storage and handling fees, commercial waste hauling, training, insurance compliance and potential fines associated with wastewater spills. 

All units are available in powder coated mild or stainless steel with electric, propane or natural gas heat sources. Standard equipment on each unit includes an oil skimmer and down stream draft inducer. 

Each unit includes:
a heat source (electric, natural gas or liquid propane) 
adjustable thermostat 
redundant safety control systems 
oil skimmer 
vent stack 
exhaust fan, which also acts as a down stream draft inducer in gas units 

Wastewater is pumped, batch fed or poured into the evaporator. Non-emulsified oils are skimmed and channeled to an external receptacle. All  evaporator units have underfloor heating that handles a high suspended solids level. The solids concentrate and remain in the evaporator for later removal. Underfloor heating simplifies the solids removal because the bottom is flat and sloped, and there are no immersion heaters or heat tubes to clean around. There is also a three inch drain port on each unit for convenient solids removal.